- Get everyone out from under it. Watch from the doorway, and do not stand under the sag for any reason.
- Cut the power to that area from a dry spot. Do not touch switches or fixtures in the room, because water tracks along the wiring in the ceiling. If you can reach the breaker panel without walking through water, switch that area off. If you cannot, leave it and call an electrician or your utility.
- Stop the water if you can. For a leaking or burst pipe, close the main water shutoff. If the leak is below the air handler, switch the air conditioning off at the thermostat. Rain coming through the roof cannot be stopped from inside, so catch it instead.
- Catch it, move what you can, photograph it. Once the power is off, put buckets under the drips and move furniture and electronics from the edges of the room, never from directly beneath the sag. Take photos from the doorway before anything is moved, and note when you last knew the ceiling was dry.
- Call the trade for the source, then a restoration company. Who does what is below.
if you smell gas, if water is reaching outlets or a live electrical panel, or if the ceiling is coming down.
Why a wet ceiling comes down all at once
Water weighs about 8.34 pounds per US gallon, so a bulge holding five gallons is hanging more than forty pounds off the drywall, plus the weight of the soaked board itself. Ceiling drywall is built to hold up its own weight and nothing more. It is the fasteners at the joists and the saturated paper facing that give way, and because they carry the load together they tend to let go together. That is why a ceiling can look stable for hours and then drop in one piece.
A dry stain is a problem to investigate. A bulge, a sag or several drips is a problem to stand back from.
Draining a bulge on purpose
If a bulge is going to release, it is safer for it to release into a bucket at a time you choose. Do this only when all of the following are true:
- The power to that area is off, and you confirmed it from a dry standing position.
- Nobody is underneath, and you are not underneath either. You work from the side, at arm's length.
- The ceiling is drywall, not plaster or heavily textured. Older plaster comes down in slabs.
- The bulge is small enough that a bucket will hold it.
Put a bucket down, stand to the side, and make one small hole at the lowest point of the bulge with a screwdriver on an extension. Puncture the middle instead and the water runs along the back of the board and finds its own way out somewhere you are not standing.
If the bulge is large, if the ceiling is plaster or textured, if you cannot confirm the power is off, or if you would have to stand under it to reach it, stop. Close the door and wait for a professional. A crew arriving to a ceiling that is still up has an easier job than one arriving to a ceiling that came down on the furniture.
Who to call, in what order
If water is still arriving, call the trade that owns the source: a plumber for a supply or drain line, an HVAC company for a condensate line, or a roofer if it only comes in when it rains (see roof leak water damage). Then call a restoration company, because insulation holds water against the ceiling board and the cavity rarely dries on its own. The EPA advises drying wet materials within 24 to 48 hours to limit mold growth, so the second call should not wait for the first job to finish.
Need someone on site today?
Call a local water damage restoration company yourself; in an emergency, the one that can be on site today wins. Before anyone starts work, ask whether the technicians are IICRC certified, because Florida has no dedicated license for the drying itself. Any mold or construction license a company quotes can be checked free at myfloridalicense.com, and this walkthrough shows how to read the result.
Once the water has stopped
When nobody needs to be under the ceiling any more, the slower questions start: what the stain means, where the water came from, whether the drywall can be dried, and what it costs. Those are in water stain on ceiling: what it means. If water reached the floor too, start with the first 24 hours.
Sources
- US Geological Survey, Water Science School, Water Density (weight of water)
- US EPA, A Brief Guide to Mold, Moisture and Your Home (24–48 hour drying guidance)